User guide

107
Displaying Chassis Configuration Information
Choosing Option 1 from the main menu will bring up the table shown above,
displaying your XP4000 system's current configuration information. You will
be prompted for a chassis number, or address, before the table is displayed.
Enter a remote chassis address or press enter at the prompt for the local unit.
Note that the slot with no push-button or LED is designated by “M” and the
primary peripheral workstation, or the LCI, channel is designated by “N”.
Downloading to Flash ROM
To upgrade your LCI, XPLU, XPXT, XPXR, XPST, XPSR, XPAB, XPSI,
XPDU or XPRB modules, you will need the latest Flash firmware revision
from Cybex. If you do not have this revision, it is available on the Internet or
from Cybex Technical Support.
Option 2 is used to transfer the contents of the current module's Flash to
another module within the system. This makes it easy to upgrade similar
modules, or store the Flash away in an XPRB storage location.
To transfer the new Flash firmware file into any module within your XP4000
system, choose Option 3. Option 3 prompts you for the address of the module
to download to. If no address is provided, the XP4000 Series unit assumes the
current module.
You will receive a message from the unit to begin XMODEM transfer. Perform
an XMODEM transfer of the revision file. During the duration of the upgrade
a front panel LED will blink.
When you have successfully uploaded the file to the unit, you will be returned
to the Configuration/Upgrade main menu. The module that you have upgraded
will automatically reset, then will run off the new upgraded firmware.
Note: If an error has occurred in transmission, the module will not attempt to
execute the new code. The old firmware will be used until the transmission is
successfully completed.
EPROM FLASH
Chan Card Type HW Rev FW Rev FW Rev Serial # Other Information
---- --------- ------ ------ ------ ----------- -----------------
3-A Empty
3-B XPAC B03 * D-00 -NA- 0123456789 PC + PS/2 mouse
3-C XPAC C00 * D-00 -NA- 0123456789 No cable attached
3-D Empty
3-E Empty
3-F Empty
3-G Empty
3-H Empty
3-I XPXT A00 * C-04 -NA- 0123456789
3-J XPXT A00 * C-04 -NA- 0123456789
3-K Empty
3-L Empty
3-M XPRB A00 * C-06 CMON 0123456789
3-N Empty
* - Indicates active device.
Channel position
Hardware revision
Standard firmware revision
Upgrade firmware revision
Module type
P1[N/C] P2 [ 4-F]
P1[N/C] P2 [ 5-F]