User guide

105
The following commands are used for system control and maintenance. Enter
the command sequences to perform the actions described in the table below.
Key Sequence Action
<CM>RESET<Enter> Resets the active user module.
<CM>RESETAddr<Enter> Resets any module in the system, computer or user.
Replace Addr with the address of the module to reset.
<CM>OFF<Enter> Logs a secondary user off of the XP4000 system. User
screen goes blank. Video channel is freed up for other users
in the system. Selecting a channel re-enables the user.
<CM>M+<Enter> Re-enables the mouse on the current active channel. Use
after switching the type of mouse connected to a user
station, or after the RESET command has been used on
the active computer interface module.
<CM>SAVE<Enter> Saves user console configuration (i.e. Swap Mode, Follow
Mode) settings to permanent memory. Any configuration
changes that are not saved will not be retained after a
power reset.
<CM>SW=nn<Enter> Overrides DIP switch settings on XPAC/XPAB computer
interface modules. Sets the bank of switches (1-8) to a user
specified ON/OFF combination. To determine the correct
DIP switch code for your system (n), refer to Appendix G.
Further instructions can be found on page 113.
<CM>SWn=1<Enter> Overrides DIP switch (n) and sets it to the ON position.
<CM>SWn=0<Enter> Overrides DIP switch (n) and sets it to the OFF position.
<CM>SW+<Enter> Enables override of DIP switch settings.
<CM>SW-<Enter> Disables override of DIP switch settings.
<CM>CHASSIS=n<Enter> Changes the unit address of the local unit to
n (0-254).
<CM>SUN=n<Enter> Non-US Sun Workstations Only Sets all XPAC/XPAB
computer interface modules attached to Suns to emulate
country-specific key codes. To determine the correct code
for your system (n), refer to your Sun workstation
documentation and Appendix H.
<CM>SUNI=n<Enter> Non-US Sun Workstations Only Sets the current XPAC/
XPAB computer interface module (Sun only) to emulate
country-specific key codes. To determine the correct code
for your system (n), refer to your Sun workstation
documentation and Appendix H.
Advanced Operations
9
System Control
& Maintenance