VR1® Glute Owner’s and Service Manual Strength Systems Part Number 13170-999-4 C www.cybexinternational.
VR1® Glute Owner’s and Service Manual Strength Systems Part Number 13170-999-4 C Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR1® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc., makes no representations or warranties regarding the contents of this manual.
Table of Contents 1 Safety Safety . . . . . . . . . . . . . . . . . . . . . . . . . Safety Guidelines and Practices . . . . Warning/Caution Decals . . . . . . . . . . Regular Maintenance Activities . . . . . Use Proper Form. . . . . . . . . . . . . . . 1-1 1-2 1-3 1-6 1-6 2 Exercises Intended Use. . . . . . . . . . . . . . . . . . . 2-1 Instructions . . . . . . . . . . . . . . . . . . . 2-2 3 Customer Service Contacting Service . . . . . . . . . . . . . . Ordering parts . . . . . . . . . . . . . . . . .
Cybex VR1 13170 Glute Owner’s Manual 1 - Safety Safety Read the Owner’s Manual carefully before assembling, servicing or using the equipment. It is the responsibility of the facility owner and/or owner of the equipment to instruct users on proper operation of the equipment and review all labels. WARNING: Serious injury could occur if these safety precautions are not observed: User Safety Precautions • Obtain a medical exam prior to beginning an exercise program.
Cybex VR1 13170 Glute Owner’s Manual • Make sure that each machine is set up and operated on a solid level surface. Do not install equipment on an uneven surface. • Make sure that all users are properly trained on how to use the equipment. • Make sure there is enough room for safe access and operation of the equipment. • Perform regular maintenance checks on the equipment. Also pay close attention to all areas most susceptible to wear, including (but not limited to) cables, pulleys, belts and grips.
Cybex VR1 13170 Glute Owner’s Manual 3. Anchoring holes are provided on the feet of the frame. All anchoring locations must be used when anchoring the equipment to the floor. 4. Due to the wide variation of flooring on which machines may be anchored or installed, verify anchoring method and anchoring fasteners with a qualified and licensed contractor. 5. A minimum pull out force of 220 lbs/100 kgs is required for each anchor position.. 6. Do not use machine until it is properly anchored.
Cybex VR1 13170 Glute Owner’s Manual A CAUTION Personal injury may occur. Keep away from moving parts to avoid injury.
Cybex VR1 13170 Glute Owner’s Manual Glute - 13170 A B C (both sides) B Description Part No. A. Warning Label....................4605-381-4 B. Caution Decal.....................4000Y316-4 C. Caution Decal.....................
Cybex VR1 13170 Glute Owner’s Manual Regular Maintenance Activities Preventative maintenance activities must be performed to maintain normal operation of your equipment. Keeping a log sheet of all maintenance actions will assist you in staying current with all preventative maintenance activities. The preventative maintenance actions are described in detail in Chapter 5. Briefly, they include: Daily 1. Clean upholstery. Weekly 1. Inspect all nuts and bolts for looseness. Tighten as required. 2.
Cybex VR1 13170 Glute Owner’s Manual 2 - Exercise MUSCLES USED Intended Use The intended use of this equipment is to aid or improve general physical fitness and exercise. For Commercial use. Instructions Read and understand all instructions and warnings prior to using this machine. See Chapter 1, Safety, in the Owner’s Manual or consult with floor staff.
Cybex VR1 13170 Glute Owner’s Manual Set Up 1. Adjust abdominal pad for comfortable support. 2. Rest lower leg and forearms on pads and grasp handles. 3. Place foot of opposite leg against foot bar. Movement 1. Push to rear and upward while maintaining body position. NOTE: Maintain contact with footbar at all times.
Cybex VR1 13170 Glute Owner’s Manual 3 - Customer Service Contacting Service Hours of phone service are Monday through Friday from 8:30 to 6:00 p.m. Eastern Standard Time. For Cybex customers living in the USA, contact Cybex Customer Service at 888-462-9239. For Cybex customers living outside the USA, contact Cybex Customer Service at 508-533-4300 or fax 508-533-5183. Find information on the web at www.cybexintl.com or by e-mail at techhelp@cybexintl.com. Ordering Parts Fax orders to 508-533-5183.
Cybex VR1 13170 Glute Owner’s Manual Return Material Authorization (RMA) The Return Material Authorization (RMA) system outlines the procedures to follow when returning material for placement, repair or credit. The system assures that returned materials are properly handled and analyzed. Follow the following procedures carefully. Contact your authorized Cybex dealer on all warranty-related matters. Your local Cybex dealer will request a RMA from Cybex, if applicable.
Cybex VR1 13170 Glute Owner’s Manual 4 - Assembly Tools Required • • • • 7/32” Allen wrench 3/4” Socket or wrench Hammer 3/16” Pin punch NOTE: Two people will be required to perform this procedure. NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance around each machine to allow for safe use and passage. NOTE: Refer to Chapter 6 for reference diagrams. 1. Read and understand all instructions thoroughly before assembling this product.
Cybex VR1 13170 Glute Owner’s Manual 5. Securely anchor machine to the floor. A. Securely anchor machine to the floor using the anchor holes provided in each machine. NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor. NOTE: Use fasteners having a minimum of 500 lbs tensil capacity (3/8” grade 2 bolts or better). NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors.
Cybex VR1 13170 Glute Owner’s Manual F. Remove guide rod cap and spring and set aside. G. Repeat steps 7D - 7F for other guide rod. H. Using a 3/16” pin punch and hammer, carefully remove roll pin securing cable end to top weight connector. See Figure 3. I. Carefully lean guide rods slightly outward. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. Cable End Top Weight Connector Roll Pin Figure 3 J. Slide top weight up and out of machine and carefully set aside. K.
Cybex VR1 13170 Glute Owner’s Manual C. Repeat steps 8A and 8B for each weight plate. D. Carefully slide top weight (removed in step 7J) over guide rods. 9. Cable routing. A. Verify cable is routed through top of pulley bracket and then route cable end to top weight connector. B. Pull cable tight and secure in place with roll pin removed in step 7H. C. Place weight stack pin in each plate to verify proper installation. D.
Cybex VR1 13170 Glute Owner’s Manual 5 - Maintenance All preventive maintenance activities must be performed on a regular basis. Performing routine preventive maintenance actions can aid in providing safe, trouble-free operation of all Cybex Strength Systems equipment. NOTE: Cybex is not responsible for performing regular inspection and maintenance actions for your machines. Instruct all personnel in equipment inspection and maintenance actions and also in accident reporting/recording.
Cybex VR1 13170 Glute Owner’s Manual More Difficult Stains • Dampen a soft white cloth with a solution of 10% household bleach (sodium hypochlorite), 90% water. Rub gently. Rinse with a water dampened cloth to remove bleach concentration. • • The same procedure can be used with full strength household bleach, if necessary. Allow bleach to puddle on the affected area or apply with a soaked cloth for approximately 30 minutes. Rinse with a water dampened cloth to remove any remaining bleach concentration.
Cybex VR1 13170 Glute Owner’s Manual 4. Guidelines for cleaning front panel: • Use clean soft cloths or sponges for application of cleaners and again for washing and rinsing. • • • Follow up the application with warm water rinse. • • Don’t apply cleaners in direct sunlight or at elevated temperatures. • Don’t clean with gasoline. Don’t use abrasives or high alkaline cleaners. Don’t leave cleaners on for long periods, wash immediately. Don’t use scrapers, squeegees or razors.
Cybex VR1 13170 Glute Owner’s Manual Weekly Procedures 1. Check all nuts and bolts for looseness. Tighten as required. 2. Inspect all cables for wear or damage and proper tension. When inspecting cables, run fingers on the cable, paying particular attention to bends in cable and attachment points. WARNING: Replace all worn cables immediately. The following conditions may indicate a worn cable: • A tear or crack in the cable sheath that exposes the cable. See Figure 1. Figure 1. • A kink in the cable.
Cybex VR1 13170 Glute Owner’s Manual 3. Inspect bars and handles for wear, paying particular attention to tab area connection points. Replace all worn handles immediately. CAUTION: Replace all worn handles immediately. Do not use if less than 1/8” of material remains to the edge. See Figure 5. Attachment Hole NOTE: Replace bar if less than 1/8” of material remains to the edge. Figure 5 4. Inspect snap links for proper latching (indicates wear) Replace all worn snap links immediately. 5.
Cybex VR1 13170 Glute Owner’s Manual Cable Adjustment Three types of cable tension adjustment are used on Cybex Strength Systems: 1. Jam Nut Adjustment - This type uses a jam nut and a tension adjustment nut at the cable cam end as the primary adjustment. The other end of the cable usually contains a roll pin adjustment. See Figures 6 and 7. 2. Rod End Adjustment - This type of adjustment contains a socket head cap screw (SHCS) securing a cable rod end bearing to the machine.
Cybex VR1 13170 Glute Owner’s Manual Environment Static Electricity - Depending upon where you live, you may experience dry air, causing a common experience of static electricity. This may be especially true in the winter time. You may notice a static build-up just by walking across a carpet and then touching a metal object. The same can hold true while working out on your unit. You may experience a shock due to the build-up of static electricity on your body and the discharge path of the unit.
Cybex VR1 13170 Glute Owner’s Manual This page intentionally left blank.
Cybex VR1 13170 Glute Owner’s Manual 6 - Service Please refer to the next several pages for parts lists, exploded-view diagrams and cable and belt routing diagrams. NOTE: All inspections and repairs must be performed by trained service personnel only. Cybex will void warranty if non-Cybex replacement parts are used.
Cybex VR1 13170 Glute Owner’s Manual This page intentionally left blank.
Cybex VR1 13170 Glute Owner’s Manual GLUTE PRODUCT NO. 13170 L K A D J H B (both sides) G C B F M G NOTE: See exploded-view diagram for location of E (cable) and I (serial number decal) A. B. C. D. E. F. DESCRIPTION PART NO. Placard Decal .................... Caution Decal .................... Caution Decal .................... Warning Label ................... Cable.................................. Chest Pad....................... ...
Service Page 6-4 1- German 2- French 3- Spanish 4- English 6- Japanese 7- Swedish 8- Russian *Language Key QTY 5 1 1 2 2 2 1 1 1 2 2 4 2 2 2 1 4 1 1 2 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 2 2 1 2 1 1 4 1 1 4 4 4 2 1 2 2 ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 DESCRIPTION 08014 PULLEY ASSEMBLY, 4.50 IN.
50 75 69 5 77 4 61 63 61 79 4 5 63 50 69 8 63 69 79 75 63 63 69 69 74 26 52 46 49 46 69 23 62 54 Serial Number Decal 2 38 33 80 63 81 78 63 69 64 6 69 63 79 32 54 9 60 62 60 28 17 3 30 63 62 7 55 54 45 42 25 27 73 62 42 45 52 45 42 70 47 70 43 6 21 29 44 68 59 67 GLUTE MAIN ASSEMBLY DETAIL 80 64 42 45 58 58 52 1 18 22 72 65 1 1 52 65 52 72 65 Cybex VR1 13170 Glute Owner’s Manual Service Page 6-5
Service Page 6-6 86 86 99 85 86 86 91 83 98 89 87 82 52 52 52 52 51 11 65 47 65 35 14 48 14 1 24 51 16 47 13 12 12 57 76 20 56 65 1 15 39 10 71 10 76 71 13 12 12 57 36 34 53 20 56 37 15 39 GLUTE PANEL AND WEIGHT PACK DETAIL 94 90 34 10lb 92 96 95 15lb WEIGHT PLATE DETAIL 31 93 97 Cybex VR1 13170 Glute Owner’s Manual
53 23 Glute Cable Routing 52 41 66 34 63 27 Cybex VR1 13170 Glute Owner’s Manual Service Page 6-7
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 www.cybexinternational.com • Techhelp@cybexintl.
