Service manual

B. Using the hex key provided, tighten the two pivot screws on the handrail. See Figure

9. Remove the left side panel.

A. Pull the left side panel away from the base. See Figure 10.

10. Arrange power cord.

A. Decide whether you will plug the power cord into an outlet near the front of the

treadmill or the back of the treadmill. Follow the corresponding routing procedure

below. NOTE: Do not plug in the power cord at this time.

Cybex TROTTER Elite Treadmill Owner’s & Service Manual

Figure 10

Left Side Panel

Figure 8

Pivot

Screws

Figure 9

Setup

Assembly

Page 5-7