User guide

Note! The maximum safe and permissible reclining position is limited by the edge of

the seat of the car seat. The child seat must not extend beyond this limit! If the CYBEX

JUNO-fix backrest loses contact with the car seat or if the seat cushion (d) rises away

from the seat of the car seat, the maximum position has been exceeded and must be

corrected.

Note! If the CYBEX JUNO-fix is used without ISOFIX CONNECT, putting the child seat

in the reclining position is prohibited!

• Now you can continue with the section “SECURING THE CHILD“

• When you have taken the child out of the car seat and want to return the seat

from the reclining to the sitting position, activate the handle (v) again and apply

slight pressure to the seat cushion (d) to guide the child seat back into the

upright position.

• Install the seat as described in the section, „INSTALLATION OF THE CHILD

SEAT WITH ISOFIX CONNECT“.

• To adjust the reclining position, activate the handle (v) on the underside of the

seat cushion (d) and pull the connectors out as far as the end stop.

SITTING AND RECLINING POSITION

In order to adjust the child seat reclining position the car seat belt must be released.

The reclining position can only be adjusted by using the ISOFIX CONNECT

system.

WARNING! Always ensure that the handle (v) locks into the reclining and sitting

positions with an audible click.