User guide

• Activate the handle (v) on the underside of the child seat.
• Pull out the ISOFIX connectors (w) as far as possible.
• Turn the connectors 180°, so that they show in the direction of the ISOFIX
GUIDES (u).
• Push the two ISOFIX connectors (w) into the GUIDES (u) until they lock into
place on the anchorage points (i) with an audible „CLICK“.
• Make certain that the child seat is securely fixed in place by trying to pull it out.
• The green safety indicator (x) must be clearly visible on both red release
buttons (y).
• You can now use the handle (v) on the underside of the child seat to adjust the
position of the seat.
• You can now secure your child in the child seat; see „SECURING THE CHILD“
x
y
If it is difficult to access the ISOFIX anchorage points (i) of your car, and to protect the
seat cover you can permanently fit the ISOFIX guides (u) provided in both anchorage
points. In many cars it is more effective to install the ISOFIX guides (u) in an opposing
direction.
INSTALLATION OF THE CHILD SEAT WITH ISOFIX
CONNECT SYSTEM
With the ISOFIX CONNECT System you can secure the child seat safely in
the car and thus make your child safer. Your child is further protected by the
security of your car‘s three-point automatic seat belt.
u
w
x
y
u
w
v
i
Note! The ISOFIX anchorage points (i) are two metal rings per seat and are located
between the backrest and the seat of the car. If you are in any doubt, consult your
car’s instruction manual for assistance.
Note! Take care that the two green safety indicators (x) on the ISOFIX connectors (w)
are not visible. If necessary, release the connectors (w) by pressing and pulling back
the red release button (y). Repeat the process as appropriate for the second connector
Note! Please refer to the section „PLACING THE CHILD SEAT IN THE CAR“.
To secure the CYBEX JUNO-fix correctly, observe the following instructions:
12