Owner`s manual

•
•
•
CYBEX CI8S$ic Owners Manual
2. Using a 3/16" pin punch and hammer, drive roll pin out of top plate connector
and cable fitting.
3. Grip cable fitting firmly, pull down to tighten cable. Rotate fitting to align roll pin hole
with
an opening in top plate connector.
4. Insert pin punch through top plate connector and roll pin hole to hold cable in place.
5. Drive roll pin through top plate connector and fitting from opposite side, pushing out
pin punch. Assure roll pin ends are flush.
6. Test cable tension (see Cable Tension Check). Deflection of 1/4" to 3/4" indicates
proper tension. If top weight plate does not rest securely against the second plate
and selector pin cannot be fully inserted, there is too much tension on the cable.
7. To readjust, if required, drive pin out of top plate connector and realign any cable
fitting pin hole with another connector opening as required to adjust tension. Check
that roll pin is flush. If cable tension cannot be corrected, contact a CYBEX
Customer Service Technician.
8. Once proper tension is achieved, fully inset selector pin and replace protective
cover over cable fitting.
Nylon Insert Nut Adjustment
TOOLS REQUIRED FOR THIS PROCEDURE:
• 7/16" Open end wrench
• Pliers
NOTE: The cable tension adjustment nut is locked by a nylon insert.
1. Grip lower section of cable fitting with pliers and tighten adjustment nut clockwise
with a
7/16" open end wrench. Make small incremental adjustments. See Figure 9.
2. Check cable tension (see Cable Tension Check). Deflection of
1/4" to 3/4" indicates
proper tension.
3. Readjust and retest if required. If cable tension cannot be corrected then contact a
CYBEX Customer Service Technician.
Page~11