Owner`s manual

CYSEX Classic Owner's Manual
5. Test cable tension (see Cable Tension Check). Deflection of 1/4" to 3/4" indicates
proper tension.
If top weight plate does not rest securely against the second plate
and selector pin cannot be fully inserted, there is too much tension
on the cable.
6. Remove rod end bearing to readjust if required. Install rod end bearing. Check
tension and selector pin fit.
7. When deflection is within limits, using a 9/16" open end wrench, tighten rod end jam
nut.
8. If correGt cable tension cannot be achieved, perform roll pin adjustment per Roll Pin
Adjustment instructions.
Cable Tension - Roll Pin Adjustment
TOOLS REQUIRED FOR THIS PROCEDURE:
• 3/16" Pu nch
• Hammer
1. Slide protective rubber cover up cable to expose cable/plate junction. Note roll pin
location
in cable fitting. See Figure 11.
Cable End J~"'::'::::---1I;;D l....-::"""'::"'"'-r-r
Top
Weight
Connector
Figure 11
Page 5-10
•