Owner`s manual

•
CYBEX Classic Owner's Manual
Cable Tension - Rod End Adjustment
TOOLS REQUIRED FOR THIS PROCEDURE:
• 9/1 6" Open end wrench
• 7/32" Allen Wrench
NOTE: For cables with a rod end adjustment at one end and a roll pin adjustment at
the other end, you must perform the rod end adjustment to correct cable
tension. Perform roll pin adjustment
if rod end adjustment does not provide
proper tension.
1. Using a 9/16" open end wrench, loosen jam nut on rod end bearing several turns.
See Figure 10.
r---~-Cable Rod End Bearing
Figure 10
2. Using a 7/32" Allen wrench, completely remove socket head cap screw (SHCS)
from assembly so that rod end bearing is free to be adjusted.
3. To increase cable tension, turn rod end bearing on threaded cable end clockwise. To
decrease cable tension, turn rod end bearing counter-clockwise.
4. Using a 7/32" Allen wrench, attach rod end bearing to frame with SHCS.
•
Page 5-9