Owner`s manual

•
•
•
CYBEX Classic Owner's Manual
Cable Tension Check
NOTE: Assure weight stack top pLate is flush with weight stack prior to, and during, cabLe
tension check.
1. Select a point on the cable half way between weight stack and pulley.
2. Push cable right or left. Cable deflection greater than
3/4" (I" for RLD units) indicates
excessive lack. Deflection
of 1/4" to 3/4" (112" to I" for RLD units) is nonnal, as is a
slight increase
in lack between checks. See Cable Tension Adjustment to adjust tension.
NOTE: The correct cabLe tension is criticaLforproper range Limiting device (RLD)
operation.
If cable is too tight, RLD start position wiLL be difficuLt to adjust.
Alternative Cable Tension Check
1. Select top weight plate (using weight selector pin).
2. Slowly rai e and lower top weight plate (in nonnal fashion).
3. Verify top weight plate i just resting on econd plate.
NOTE (1): If there is too much tension then the top weight pLate wiLL not properly rest on
second weight and the weight stack selector pin may be difficult to insert into weight pLates.
NOTE (2): Too much sLack is indicated if top weight pLate does not Lift immediately after
raising top weight pLate (in normaL fashion). A slight
sLack in cabLe is ok.
NOTE (3): The correct cabLe tension is criticaL for proper range limiting device (RLD)
operation.
If cabLe is too tight, RLD start position wiLL be difficuLt to adjust.
4. Adjust cable if there is too much tension or too much slack. See Cable Tension
Adjustment to adjust tension.
NOTE: The roLL pin adjustment for RLD units should be one to two holes Looser than for
non-RLD units.
Page 5-7