Owner`s manual

•
CYBEX Classic Owner's Manual
Yearly Procedures
Replace all cables at least annually.
"As Required" Procedures
1. Inspect grips and replace as necessary.
2. Clean Range Limiting Device so that the cam tracks are wiped clean and lightly lubricated
with a Teflon base spray lubricant (Superlube®).
3. Remove Cable End Bearings and lubricate thoroughly with a medium-weight automotive
engine oil.
To lubricate: Loosen rod end bearing jam nut with a 9/16" wrench. Using a
7/32" Allen wrench, remove the socket head cap screw (SHCS) and rod end bearing from
unit. Coat bearing thoroughly with oil inside and out and reattach to unit.
Cable Adjustment
Tension Adjustment Nut
I'-J.-~_--Jam Nut
• Three types of cable tension adjustment are used on CYBEX Strength Systems:
1. Jam Nut Adjustment - This type uses a jam nut
and a tension adju tment nut at the cable cam
end as the primary adjustment. The other end
of the cable usually contains a roll pin
adjustment. See Figure 6 and
8.
Figure 6
•
Page 5-5