Owner`s manual

•
•
•
CYBEX Classic Owners Manual
Weight Stack Installation
TOOLS REQUIRED FOR THIS PROCEDURE:
• 5/16" Allen wrench
• Soft hammer
MATERIALS REQUIRED
• Medium weight automotive engine oil.
1. Remove the two flat head socket cap screw (or socket head cap screws) ecuring the guide
rods.
2. Carefully lean guide rod away from weight tack guard on
aJi machines except the
Shoulder IntemaVExtemal Rotation and Wri t
& Forearm machine. For these machines
only, lean guide rods toward weight stack guard.
3. Remove guide rod collets and plastic
cap.
4. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
5. Install each weight plate, one at a time, beginning with highest numerical value. OTE: For
15 and 25 weight plate stacks, the first plate installed has no number.
6. Install top weight.
7. Replace plastic caps and guide rod collets on guide rods.
8. Return guide rod to full upright position.
9. In ert both flat head ocket cap screws removed in tep 3 and tighten ecurely.
10. Insert cable end into top weight and align cable fitting opening with opening in top weight
for proper cable ten ion.
See Cable Adjustment and Installation section.
II. sing a hammer, drive roll pin through top weight cable connector hole and cable fitting.
Assure pin
is flu h with top plate collar. See Figure 12 on next page.
PSg84-3