Owner`s manual

Extension Handrails - Optional
Tools Required
• Razor blade or knife
• 1/4” Hex key (supplied)
• Mild dish soap and water solution
• Clean cloth
NOTE: “Right” and “left” are from user’s
orientation.
1. Please read instructions thoroughly
before beginning.
2. Verify the appropriate kit and
contents. See Figure 37.
NOTE: This instruction describes assembly
of both the extension handrails.
If you are installing only one of
the two handrails then follow the
instructions for only the side you are
replacing.
3. Remove the handgrip from the
treadmill.
A. Using a razor blade, carefully
slit each handgrip that is on the
treadmill. See Figure 38.
B. Carefully pull back each grip until it
comes off the treadmill.
4. Install the handrail extensions.
A. Remove the handrail assemblies
from the wrapping and cardboard.
IMPORTANT: Carefully follow steps 4B
and 4C. Failure to do so
could result in ripping the
handrail.
B. Dampen a clean cloth in a mild
soapy water solution and spread it on each console handrail. Feel the handrail to be sure it is
slippery. See Figure 39.
Cybex 445T/455T Treadmill Owner’s Manual
Setup
and
Assembly
Page 5-10
Included in Kit CK-19962
A. Handrail assembly left,
AX-19735 (1)
B. Handrail assembly right,
AX-19758 (1)
C. Bolt, HS-18127 (4)
D. Lock Washer, 1/4” Ext. Tooth, HW-00180 (4)
E. 1/4” Hex key, HX-17117 (2)
Figure 37
B
A
Slit Each
Handgrip
Figure 38
CK-19960
Left Handrail
CK-19961
Right Handrail
CK-19962
Both Handrails
E
C
E
C
E
C
A
B
D
D
D