Owner`s manual

Cybex 445T/455T Treadmill Owner’s Manual
#16
#6
#8
#16
#7
Setup
and
Assembly
Page 5-8
Figure 11
D. Check to see that all of the cables
are connected firmly in their proper
place. See Figure 8.
E. While being sure not to pinch any
cables, use a Phillips screwdriver
to secure the seven screws 8-16
x .50” (#14) that hold the console
assembly (#2) to the console back
(#4). See Figure 9.
F. Using a Phillips screwdriver secure
the two screws (#13) securing
the console assembly (#2) to the
upright assembly (#3). See Figure 9.
G. Using a Phillips screwdriver
secure the two screws (#14)
securing the console back cover
(#5) to the console front (#4). See
Figure 10.
9. Attach the motor cover (three
pieces).
A. Using a Phillips screwdriver,
partially tighten each motor cover
side (left and right) with four
screws, 10-32 x .75” (#16). See
Figure 10.
B. Place the motor cover center (#6)
into position. See Figure 11.
C. Using a Phillips screwdriver, finish
tightening all four screws. Be sure the screws are securing the motor cover’s tabs.
Figure 9
Console
Assembly
Back
Cover
Screws
Figure 10
Screws
Machine Screw
Console
Assembly
Upright
Assembly
Console
Back