User guide

AutoView 424 Installer/User Guide

Configure your terminal program to the following settings:

38,400 Baud

8 Bits

No Parity

1 Stop Bit

No Flow Control

Once setup is complete, the following steps will finish the upgrade:

1. Activate the OSD menu on your AutoView 424 by tapping the Control key

twice. Enter Control twice more to activate the Administrator Commands

screen and then select Administrator Functions.

2. Use the down arrow key to highlight the menu selection for FLASH

Upgrade, then press Enter.

3. A menu screen will appear, requiring verification to continue. You must

type out the word ‘Yes’ before proceding. Once you have done this, the

AutoView 424 will go into a standby mode and wait for data from the

computer. (Note: The keyboard, video and mouse are disabled during the

FLASH upgrade.)

4. The final step is to send the FLASH file from your terminal program. To

do this, you will need to use the transfer function of your communications

software. Send the FLASH file using the XMODEM protocol. The transfer

should be completed within four minutes.

The AutoView 424 will automatically check the upgrade and make sure that

it is valid. If the AutoView 424 detects an error it will abort the upgrade and

prompt you to re-transfer the file. Otherwise, it will return the message

“Flash Upgrade Successful”.