User guide

C: FLASH

Upgrading

To upgrade the FLASH code on your AutoView 424, you will first need to

obtain the latest FLASH firmware revision from Cybex. It is available through

Cybex Technical Support.

Next you will need a serial cable (available at most electronics stores) to

connect a computer to your AutoView 424. Simply connect the serial

cable between the SETUP port on your AutoView 424 to the serial port on

the computer.

You will next need some form of terminal software on your attached computer

so that it can communicate with the AutoView 424. There are several that

are commercially available. Select one that you are comfortable with and be

sure that it can communicate at 38,400 baud.

Appendices