User guide

AutoView 424 Installer/User Guide

The following commands are used for system control and maintenance.

Enter the command sequences to perform the actions described in the

table below.

System Control &

Maintenance

Key Sequence Action

<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are

using a PC with a standard PS/2 mouse driver.

<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a loss of mouse

signal. Use this command to restore the signal if you are using a PC

with a Microsoft IntelliMouse or other wheel mouse driver.

<CM>AV<Enter> Displays the current firmware version of your AutoView 424.

<CM>SG<Enter> Enables the scan Go command (By address only)

<CM>SH<Enter> Enables the scan Halt command

<CM>M+<Enter> Enables mouse suspension of scanning

<CM>M-<Enter> Disables mouse suspension of scanning

<CM>H1<Enter> Changes the hot-key sequence to the default: (NumLock, -)

<CM>H2<Enter> Changes the hot-key sequence to the 1st alternate: (NumLock, *)

<CM>H3<Enter> Changes the hot-key sequence to the 2nd alternate: (CTRL, ~)

<CM>OSD0<Enter> Disables the OSD Sequence

<CM>OSD1<Enter> Changes the OSD sequence to the default: (CTRL, CTRL)

<CM>OSD2<Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt)

<CM>OSD3<Enter> Changes the OSD sequence to the 2nd alternate: (Shift, Shift)

<CM>ZM

<Enter> Use this command to resynchronize the mouse after a device or

computer hot-plug. Repeat, if necessary, until synchronization is

re-established.

Note: Using this command while the mouse is operating

correctly will cause the mouse to lose sync.