User guide

AutoView 424 Installer/User Guide

The following notational conventions appear throughout this chapter to

illustrate commands for operating the AutoView 424. Whenever you see one

of the symbols listed on the left side of the table, substitute the corresponding

steps or values listed on the right side of the table.

Keyboard Control

Convention Key Sequence or Value

Enter Command Mode:

<CM> 1. Press and hold down the ‘Num Lock’ key.

2. Press and release the minus (-) key on the numeric keypad.

3. Release the ‘Num Lock’ key.

Note: For alternate hot-key sequences, see ‘System Control &

Maintenance’ later in this chapter.

<Enter> Press the ‘Enter’ or ‘Return’ key. The <Enter> command is used to

execute an instruction and exit from Command Mode.

Addr

The numbers on your AutoView 424 are your computers' addresses.

Enter the number, 1-24, for the computer you're selecting. For

cascaded systems, enter the address of the base unit, followed by a

period, then the address of the cascaded unit.

Example

: You have an AutoView 424 unit cascaded from channel

4 of your base unit. To access the computer at channel 3 of this

second (cascaded) unit, enter 4.3.

<ESC> Press the ‘Escape’ key. The <ESC> command is used to exit

Command Mode without executing an instruction.