User guide

AutoView 424 Installer/User Guide
6
Connecting your Remote Peripherals
3. Plug a standard Category 5 Unshielded Twisted Pair cable (up to 500
feet) into the RJ-45 style modular jack on the rear of the AutoView 424.
Cybex C5T or Cybex P5T cable is strongly recommended to achieve best
performance and maximum distance. If you use a different Category 5
cable, make sure it is terminated to the EIA (TIA) 568 B standard,
commonly used for 10BaseT Ethernet.
4. Route the Category 5 cable to the location where you intend to place
the secondary monitor, keyboard and mouse.
5.
If you are using Remote PS/2 peripherals
Connect your monitor, keyboard and mouse to the connectors on the
rear of the LongView Receiver just as you would connect them to your
computer. Make sure you connect your monitor’s power supply to
appropriate electrical outlets. (Please note that the connector on
the rear of the Receiver is not used in any AutoView 424 configuration.
Do not connect anything to this connector.)