Owner`s manual

The Load Leg is an effective safety feature of the Aton 2 and using it is

STRONGLY RECOMMENDED. However, if necessary (e.g. in a center position

with a hump in the oor), the Base may be installed with the Load Leg folded

up underneath.

If ALL installation requirements for the Load Leg cannot be met, you MUST

choose another seating position, or install the Infant Carrier without the Base.

WHEN POSSIBLE, INSTALL the Aton 2 Base in a seating position that will

allow the Load Leg Foot to be extended into a LOCKED position with rm

contact with the vehicle oor.

NEVER INSTALL the Aton 2 Base in a seating position where the Load Leg,

even in its shortest position, causes the Base to be pushed up above the

vehicle seat. If necessary, the Base may be installed with the Load Leg

folded up underneath.

NEVER EXTEND the Load Leg Foot beyond the FIRST hole that will lock it

rmly against the vehicle oor.

To Extend

1. Install the Base making sure Recline Angle is correct for your child.

2. Squeeze the Adjustment Handle on the Load Leg and

extend the Foot until it rests on the vehicle oor.

3. Secure the Foot into place using the rst hole that will lock it rmly

against the vehicle oor without lifting the Base up off of the seat.

It may be necessary to lift up slightly on the Base to allow the Foot to lock

into the hole.

To Retract

Squeeze Handle and retract Foot.

Use the FIRST hole

that will lock the

Load Leg Foot rmly

against vehicle oor

There should NEVER be any

space between the Load Leg

Foot and the vehicle oor.

The Base should NEVER

be pushed up above the

vehicle seat.

Using the Load Leg