Service manual

Product Number 8800/8810 Owner’s Manual
Assembly
Page 4-2
5. Securely anchor machine to the fl oor.
Securely anchor machine to the fl oor using the anchor holes provided in each machine.A.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs tensil capacity (3/8” grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in
contact with surface using fl at washers.
6. Install weight plates.
Using a 7/32” Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) A.
securing the top cap to the frame. See Figure 1.
Figure 1
BHSCS
Top Cap
Remove top cap and BHSCS and set aside.B.
Carefully lift shroud up and out of machine. C.
Slide spring loaded guide rod cap down guide rod until cap is clear of frame. D. NOTE: Guide rod cap is
spring loaded.
Figure 2
Shroud
Compression
Spring
Guide
Rod Cap
Guide
Rod Cap
Compression
Spring
Slowly release grasp E.
of guide rod cap.
See Figure 2. NOTE:
Guide rod cap con-
tains a
compression spring
that will fl y if grasp is
not released slowly.
Remove guide rod F.
cap and spring and
set aside.
Guide Rods