Service manual

Modular Seated Leg Press
5652 - Modular/Tandem configuration
5322 - Free Standing configuration
TOOLS REQUIRED
• 5/32” Allen wrench
• 7/32” Allen wrench
• 5/16” Allen wrench
• 3/8” Allen wrench
• 9/16” Socket/wrench
• 3/4” Socket/wrench
• Rubber mallet
• Step ladder
NOTE: A minimum of two people will be required to assemble the Leg Press configuration.
1. Read and understand all instructions thoroughly before assembling the Leg Press (see steps
A - C).
A. Locate the Modular Assembly & Service manual that you received with your order. If you did
not receive a manual contact Cybex Customer Service and ask for part number 55620.
B. If you are assembling the Leg Press station into a Tandem configuration, locate and review the
Tandem Center Post instructions contained with the Tandem configuration (this sheet is also
located in the Modular Assembly & Service manual). Skip step 1 in the Tandem Center Post
instructions.
C. If you are assembling the Leg Press station into a Modular configuration, locate and review
the Modular Center Post instructions contained with the Modular configuration. Skip step 1 in
the Modular Center Post instructions.
2. Verify you have received the appropriate configuration (see steps 2A - 2C, Figures 1 and 2).
• Hammer
• Utility knife
• Automotive engine oil
Assembly Instructions
Unpacking
A. If you ordered the Modular/Tandem
configuration (5262):
Shipping Package Part Number
• Leg Press Column 5562-9x
• Leg Press Package 5652-50
• Weight Package 4700S040
• Weight Package 4700S129
• Top Weight Package 4700-027
• Cushion Set 8630-010
B. If you ordered the Free Standing
configuration (5322):
Shipping Package Part Number
• Leg Press Column 5322-9x
• Leg Press Package 5652-50
• Leg Press Stabilizer 5302-51
• Weight Package 4700S040
• Weight Package 4700S129
• Top Weight Package 4700-027
• Cushion Set 8630-010
Cybex Modular Owner’s Manual
Page 4-9