Service manual

Cybex Modular Owner’s Manual
Page 4-2
9. Insert both socket head cap screws that were removed in step 1 and tighten securely.
10. Insert cable end into top weight and align cable fitting opening with opening in top
weight for proper cable tension. NOTE: See Cable Adjustment and Installation Section.
11. Using a hammer drive roll pin through top plate connector and cable fitting. Assure pin is
flush with top plate collar.
12. Insert selector pin into each plate to assure proper alignment. See Cable Adjustment and
Installation section if selector pin does not fit smoothly, or if cable appears to have
excessive slack.
13. Place half weight on weight peg (if applicable).