Owner`s manual

Cybex 800S Stepper Owner’s Manual
Remove the water bottle holder (7) from the
configuration kit (5). Attach the water bottle
holder to the console back plate using
three #10 screws (16), as shown in Figure 7.
Attach the water bottle holder to the back
plate using three screws. Important: if you
choose not to install the water bottle holder,
you must still screw the three screws into
the open holes in the back plate to protect
the electronics from the environment.
Leveling the 800S Stepper
The 800S Stepper rests on two wheels at the front of the stepper and on two height-
adjustable feet at the rear. First, move the stepper to where it will be used. See if you can
rock it from side to side. If so, or if it is not level, turn one or both of the rear adjusting feet
until the stepper is stable (you may need to loosen the lock nut(s) first). Once stable, tighten
the lock nuts on the adjustable feet against the frame.
Page 2-5
7A
DETAIL 7A
7
16
Figure 7-Attaching the Water Bottle Holder