Owner`s manual

Cybex 800S Stepper Owner’s Manual
Attaching the Display Console to the Handrails
Remove the display console (6) from the configuration kit (5). Attach the display ribbon cable
and the heart rate monitor cable to the connectors (A and B) on the back of the console, as
shown in Figure 5. Each cable will fit only one connector. Attach the green ground cable to the
single flat connector (C) next to the ribbon cable connector.
Page 2-4
6
A
B
C
6A
DETAIL 6A
16
6
D
Figure 6 - Attaching the Display Console to the Back Plate
Figure 5 - Plugging Cables Into the Console
After connecting all cables, attach the display console to the console back plate (D) with four
#10 screws (16) as shown in Figure 6.