Owner`s manual
Cybex 770T-CT Treadmill Owner’s Manual
35
The Setup options are:
Time and Date See Initial setup above
Units and Power See Initial setup above
Workout times Set Default and Max time
Limits Set minimum speed, maximum speed and maximum
incline
Language Select language to use for CardioTouch text
Exit Set Up Mode.
Exit Set Up Mode by
1. tapping the Toolbox icon , then tap the Home icon . The screen
will refresh.
Your treadmill is now ready for use. Proceed to Testing the Treadmill Operation. Follow the
instructions in the Operation chapter to learn how to operate the treadmill. You should begin with
walking speeds rst, to be sure everything is functioning properly.
WARNING: Be sure that all electrical requirements are met as indicated in the
specications at the front of the manual and at the beginning of this chapter
prior to proceeding.
Testing the Treadmill Operation
Use the following instructions to test the full speed and incline range of the treadmill and to check the
belt for proper operation.
CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet on
the two steps.
Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
Without anyone on the treadmill, plug the power cord into a power outlet from a grounded, 1.
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the treadmill.
Locate the on/off (I/O) power switch under the front end of the treadmill. Toggle it to the on 2.
position (I).
The control panel will light up and be in the opening screen.3.
Press the 4. Quick Start key. The treadmill begins a countdown “3...2...1” and sounds a tone
for each count. After it reaches one (1), the treadmill gives a longer tone and then begins
accelerating the belt to reach 0.5 mph (0.8 kph).
The lower left display will show the incline and the lower right display will show the actual 5.
speed.