Owner`s manual

Cybex 770T-CT Treadmill Owner’s Manual
29
Plug the display cable, located at the bottom of the upright assembly into the communication 1.
port of the controller.
Display
Cable
(Black)
CSAFE
Cable
(Red)
A/V
Cable
Communication
Port
Controller
Power
Supply
Cable
Install the Power Supply.
Locate the power supply, clamp and screw.1.
Console Cable
DIN Connector
Power
Supply Inlet
Power Supply
Output
Gray Cable
Clip
Clamp
AC Cord
Screw
Secure the power supply to the base using clamp and screw.2.
Plug the AC cord into the power supply inlet.3.
Route console cable through the gray cable clip.4.
Connect the console cable’s DIN connector to the power supply output. Make sure the two 5.
connectors snap rmly together and can not be pulled apart without pulling the sleeve back to
release it.