Owner`s manual

Cybex Arc Trainer 620A/629A Owner’s Manual
Setup
and Assembly
Page 5-13
Figure 19
To Fitness
Equipment
RJ-45
Power Inlet
12 VDC
Antenna/
Cable
Source
(Coax Cable)
To CSAFE
Device
E. Using a 3 mm Allen wrench secure
the monitor bracket to the monitor
mount using the four mounting
screws (K), four lock washers (L)
and four flat washers (M).
See Figure 18.
F. Insert the power cable, coax cable
and RJ-45 cable into the monitor
as shown in Figure 19. NOTE: Use
of the CSAFE port is optional and
requires a CSAFE cable and device.
Figure 18
(H)
(M)
(K)
Monitor
Mount
(L)
RJ-45
Cable
(B)
Power
Cable
(B)
Coax
Cable
Monitor
Bracket
Figure 17
7. Install monitor.
A. Locate monitor (H), four mounting screws (K), four lock washers (L) and four flat washers (M).
B. Remove the back cover from monitor (H) by pressing the bottom tabs of the cover in
and rotating out. See Figure 17.
C. Insert the power cable end of (B) through hole on left side of monitor mount. See Figure 18.
D. Insert the RJ-45 cable and the coax cable end of (B) through hole on right side of monitor
mount. See Figure 18.
D
D
(H)
Back
Cover
Tab
Tab
NOTE: Press in bottom of tabs and rotate out.