Owner`s manual

Cybex Arc Trainer 620A/629A Owner’s Manual
Display Console
Display
Console
Cable
Figure 14
Console
Mount
B. Locate the coax and power cables
exiting the top of the Arc frame.
C. Insert the coax and power cables
into the bottom of the console
mount until 8” (20 cm) of cable
exits the top. See Figure 14.
NOTE: Exactly 8” (20 cm) of cable must exit
the top of the monitor mount.
5. Attach the Console Assembly.
A. Locate the console assembly, four
BHSCS (Button Head Socket Cap
Screw) and four lockwashers.
B. Plug the upper display cable into
the lower display cable in the main
frame assembly. See Figure 15.
NOTE: Ensure cable connectors are
securely fastened.
C. With 8” of coax and power cables
exiting the top of the console
assembly, pull the extra coax and
power cables out of the bottom of
the main frame.
D. Attach the console assembly to
the main frame using the four
lockwashers and four BHSCS as
shown in Figure 15.
NOTE: Confirm that no cables are pinched
lowering the console.
NOTE: Do not securely fasten screws at
this time.
6. Installing Handrail Assembly to the
Console Assembly.
A. Plug the heart rate cable connector
from the console assembly to the
heart rate connector from the
handle assembly. See Figure 16.
B. Using a 7/32” Allen wrench, attach
the two BHSCS securing the
handle assembly to the console
assembly. See Figure 16.
C. Continue on with step 6E on page
5-6.
RJ-45
Cable
Figure 15
Lower
Display
Cable
Upper
Display
Cable
Console
Assembly
BHSCS
(4)
Lockwasher
(4)
Handle
Assembly
Figure 16
Heart Rate Cable
Console
Assembly
BHSCS
Heart Rate
Cable
Handle
Assembly
Opening
Main Frame
Assembly
Coax & Power
Cables
Coax & Power
Cables
Coax & Power
Cables
8”
(20 cm)
Setup
and Assembly
Page 5-12