Service manual

15. Reattach the cover to the console.
A. Using a Phillips screwdriver, reattach the four
screws securing the rear console cover to the
front console cover. See Figure 12.
16. Attach the RJ-45 and audio cables to the
signal isolator.
A. Attach the RJ-45 (C) and audio cables (B)
to the signal isolator (Q). See Figure 17.
Figure 17
(C)
(B)
(Q)
B. Insert the RJ-45 (C) cable down through
the lower rear console cover opening.
See Figure 17.
17. Attach the signal isolator.
A. Attach signal isolator (Q) cable to the PC
board. See Figure 17.
B. Peel off backing from tape and attach the
signal isolator (Q) to the mounting plate.
See Figure 17.
18. Reattach the battery door cover to the
console.
A. Using a Phillips screwdriver, reattach the
one screw securing the console battery
door cover to the console cover. See
Figure 12.
Mounting
Plate
20. Attach the console mount.
A. Position the console mount (A) on the main
frame assembly and hand thread each of the
three BHSCS. See Figure 18.
B. Securely fasten the BHSCS with the 7/32” Allen
wrench.
21. Insert the coax, power and RJ-45 cables.
A. Route the coax and power cables up through
the monitor mount until 8” (20 cm) of cable
exit the top. See Figure 18.
NOTE: Exactly 8” (20 cm) of cable must exit the top of
the monitor mount.
B. With 8” of coax and power cables exiting
the top of the console assembly, pull the
extra coax and power cables out of the
bottom of the main frame.
C. Insert the RJ-45 cable that is attached to the
display console up through the monitor mount.
See Figure 18.
22. Attach the display console.
A. Connect the console and heart rate cables
exiting the top of the console mount to the
console. See Figure 18.
Figure 18
Display
Console
Console, Heart
Rate, Coax and
Power Cables
BHSCS
(3)
(A)
BHSCS
(4)
Lockwasher
(4)
Heart Rate
Cable
RJ-45
Cable
Monitor
Mount
Power
Cable
Console
Cables
Coax
Cable
8”
(20 cm)
19. Install cables in console mount.
A. Locate the console mount (A).
B. Locate the console, heart rate, coax and
power cables on the mainframe assembly.
C. Insert the cables into the bottom of the
console mount (A) until the cable exit the
top. See Figure 18.