Service manual

Arc Trainer
®
425A Drive Link
Kit No. 425AK002
Installation Instructions
NOTE: This instruction sheet describes how to
replace the Drive Link in the Arc Trainer
425A.
Tools Required
• Phillips screwdriver • 3/4” Open end wrench
• 5/32” Allen wrench • 5/16” Allen wrench
1. Read and understand all instructions thoroughly
before installing this kit.
2. Verify kit contents. See Figure 1.
Figure 1
A
A. Drive Link, (1), 425AK002
B. Loctite, (1), YA000201
B
3. Disconnect the external power source.
A. Unplug the power cord from the power outlet.
! WARNING: Disconnect the power cord before
continuing this procedure. Keep wet
items away from inside parts of the
unit. Electrical shock could occur
even if the unit is unplugged.
B. Remove top cover.
6. Remove upper side cover.
A. Using a Phillips screwdriver, remove the
screw securing the upper side cover.
See Figure 4.
Figure 2
Screws
(4)
Front
Cover
Figure 3
Screw
4. Remove the front cover.
A. Using a Phillips
screwdriver, remove
the four screws
securing the front
cover. See Figure 2.
B. Remove front cover.
5. Remove top cover.
A. Using a Phillips screwdriver, remove the
screw securing the top cover. See Figure 3.
Figure 4
Locking
Connectors
Upper Left
Side Cover
Screw
B. Remove upper side cover.