Service manual

STEP 12-Installing the Belt Drive

(Tools required–One 1/8” Allen wrench.)

1. Select one belt retainer and two 1/4 x 5/16” long set screws.

2. Route the drive belt over the drive pulley to its corresponding

side.

3. Twist the drive belt 90 degrees so that the flat surface of the

belt will engage the surface of the idler pulley. (See figure 3-

33.)

4. Route the drive belt around the pulley. (See figure 3-33.)

5. Twist the drive belt 90 degrees so that the teeth surface of

the drive belt will engage the drive pulley.

6. Route the drive belt over the drive pulley. (See figure 3-34.)

7. Attach the drive belt to the other foot plate following the

instruction in Step 11-Installation, “Attaching the Drive Belt

to the Foot Plate”.

STEP 13-Attaching the Extension Spring to the

Spring Shaft

(No tools required.)

1. Grasp the tension spring and pull and hold down. (See figure

3-35.)

2. Slip the loop onto the spring shaft. (See figure 3-36.)

Fig. 3-35

Fig. 3-36

3 / INSTALLATION

Fig. 3-33

Fig. 3-34