Service manual

STEP 4-Installing the Short Linkage Rod Assembly

(Tools required–Two 3/4” wrenches.)

1. Select one short rod end assembly along with two 1/2-13 x

1.75” long bolts, and two 1/2-13 lock nuts. (See figure 3-10.)

2. Orient the linkage rod assembly so that the left hand

threaded parts are facing the front end of the unit. (See figure

3-10.)

3. Slide the short linkage rod assembly into the front linkage

assembly. (See figure 3-11.)

4. Slide from the top one 1/2-13 x 1.75” long bolt through the

assembly.

5. Attach on 1/2-13 lock nut and tighten to 50 ft-lb minimum.

(See figure 3-11.)

6. Position the short linkage rod assembly against the inside

surface of the front pivot and in line with lower 1/2” diameter

hole. (See figure 3-12.)

7. From the inside of the unit slide one 1/2-13 x 1.75” long bolt

through the assembly. (See figure 3-12.)

8. Attach one 1/2-13 lock nut, positioned inside the tube, and

tighten to 50 ft-lb minimum. (See figure 3-12.)

3 / INSTALLATION

Fig. 3-10

Fig. 3-11

Fig. 3-12

Fig. 3-13