Service manual

Cybex VR3 12231 Dip/Chin Assist Owner’s Manual
Assembly
Page 4-4
Install but do not tighten remaining BHSCS securing shroud. C.
Tighten all BHSCS. D.
10. Install weight plate decals.
Slowly and carefully peel off back side of decal. A. NOTE: When
peeling off back cover, make sure that the decals remain
attached to the front sticker. Figure 6.
Insert a guide pin through each hole of the template.B.
NOTE: A guide pin can be anything that fi ts through
the weight stack hole, such as a weight stack
selector pin.
Carefully align decal and rub it onto weight plates. C.
Carefully remove front side, leaving decals adhering D.
to weight plates. See Figure 7.
NOTE: It is important that you perform regular inspection
and maintenance activities on your equipment.
See the CYBEX VR3 Owner’s Manual for
inspection and maintenance activities. If you do
not have a CYBEX Owner’s Manual or if you have
any questions or concerns, call CYBEX Customer
Relations at 1-800-766-3211.
11. Verify proper operation
12. Securely anchor machine to the fl oor.
Securely anchor machine to the fl oor using the anchor holes provided in each machine. A.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile capacity ( 3/8’’ grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in
contact with surface using fl at washers.
Figure 7
180
81.0
9
0.0
20
9.0
72.0
63.0
54.0
45.0
36.0
40
18.0
140
120
100
80
60
160
Guide Rod
Pounds
Weight Stack
Kilograms
Front
Back
Figure 6