Specifications

54 CHAPTER 5
ERROR TRACKING
CHAPTER 5
ERROR TRACKING
Error: The computer can't be started
Check if the power supply cable has stable contact. If this is so, kindly contact your retailer.
Error: autoconfig-error
If after the starting of the computer resp. after a reset a red screen appears with the title
"Expansion Board Diagnostics", then please refer to your retailer.
Error: A SCSI unit is not recognized
Check if the unit is conected to the internal power supply.
For external units: Check if the power supply cable of the external unit is connected correctly,
and if the unit is switched on.
Check the SCSI ID of the connected units.
Check the connection of the SCSI cable on the CYBERSTORM PPC SCSI controller and on
the SCSI unit.
For external units check the correct position of the external SCSI cables.
Check the correct SCSI-bus-termination.
If necessary exchange the cable or connect (for internal units) the SCSI unit to another plug
of the cable, to find out eventual errors of the cable.
Error: The partitions of a disk which was formatted earlier are not recognized
First you should check with the program UnitControl which is delivered together with the
CYBERSTORM PPC if the respective hard disk is physically recognized. If this is not the
case, please carry out the instructions of the previous error description. If the disk is
recognized, check if the formerly used controller was RDB compatible, and also oblige the
step-by-step instruction for the configuration of a hard disk. If with the instructions given there
you still can not configure the disk, please refer to your retailer before you undertake further
measures.
Error: During operation of a hard disk, transmission errors occur
Check the correct SCSI bus termination resp. termination of the individual connected units.
Check the SCSI IDs of the connected units.
PowerUP - Amiga Goes PowerPC
http://powerup.amigaworld.de