Specifications

40 CHAPTER 2
INSTALLATION
7. Before the carrier board is inserted, the two clock jumpers marked on the main board
under the CPU-board with "INT" or "I" and "EXT" or "E", (see Figure 3), have to be put in
their proper position. For the operation of the CYBERSTORM PPC they have to be placed
in position "EXT" or "E". Depending on whether you are using an AMIGA 4000/030 or
AMIGA 4000/040, these jumpers by default are set to on position "EXT" or position "INT".
Please take note that the operation of the CYBERSTORM PPC is not possible if the
jumpers are set to position "INT", and the computer will not boot in such a wrong position.
Figure 3.
Position of clock
jumpers, which have to
be set correctly.
Figure 4.
Installation of the
CYBERSTORM PPC.
The cirdes mark the
positions of the drill
holes, into which the
spacers must be engaged.
8. The carrier board is installed into the computer by means of placing it onto the spacers
first, and then pushing them down (see Figure 4). Please make sure that the board is kept
in place by the spacers and also sits properly in the processor plug.
PowerUP - Amiga Goes PowerPC
http://powerup.amigaworld.de