Specifications

5. In order to exchange the processor board, it is necessary to remove the hard disk in the

rear drive as well. In order to remove the hard disk, just loosen the four mounting screws

and lift up the hard disk with its attachment. The connecting cables are long enough so

that you can put down the hard disk on the power supply unit without having to disconnect

the cables.

Figure 1.

Slight tilting to the side

makes it possible to

take the CPU-board out

of the housing after

the connectors have

been loosened.

6. Afterwards, the processor board is taken out of the computer as shown in figure 1. If the

board can hardly be moved, you should take care that the four spacers are also loose.

Now the board can be taken out of the computer by slight tilting. If the spacers sit not on

Figure 2.

The

CYBERSTORM PPC

has to be placed on

these spacers.

the main board but on the processor board, you should put these back in their foreseen drill

holes on the main board, as shown in Figure 2. This is required to make the installation of

the CYBERSTORM PPC system as easy as possible. For owners of AMIGA 4000/030, two

additional spacers are supplied with the delivery.

PowerUP - Amiga Goes PowerPC

http://powerup.amigaworld.de