User manual
Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 9 of 43
printer port on your PC you will be using to connect the printer. This will usually be LPT1
unless your PC has two printer ports and one is already in use by a non-Cyberview device.
4. Click Next.
5. The driver installation should complete and prompt you to click Finish when done.
To install driver software ONLY (LPTUSB upgrade) from an MSI:
1. Ensure the printer and scanner are NOT connected to the target PC.
2. Run the supplied executable (Cyberview_Printer_Scanner_Driver.exe).
3. You will see the following screen:
4. Click Next.
5. You are prompted to select your printer model. The product number can be found on the
underside of the printer. You are also prompted to select the printer connection type. USB
support will always be installed, but selecting LPT1 or LPT2 will additionally start the Cy.sys