User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 8 of 43
3.1.4 Motherboard – ECP devices
The x86 board must support the ECP mode and 8-bit DMA if using ECP devices. Hardware
configurations have been tested on the following chipsets:
PCI/ISA bridge: 82371XX or compatible (supports DMA Type F)
Super I/O: PC87338XXX, PC87306XXX and FDC37C66X for
When DMA Type F is available, data transfer rates on the ECP interface is increased by up to 30%
over standard DMA.
Various brands and models of ECP chipsets are not compatible at the hardware level. If chipsets other
than those listed above are present on the motherboard, the low level Cyberview software may not
recognize them. In such cases, some special low level adaptations may be required. Attempting this
will require detailed hardware specifications of the chipsets used.
3.2 Installing on: Windows 2000 and Windows XP
Driver and SDK installation on Windows 2000 and Windows XP is performed using an installation
Wizard. Upon CD insertion, you are presented with the following screen:
If the installation is an upgrade of the driver software only using an MSI rather than the SDK CD, this
screen will not be seen.
3.2.1 Installing driver software
To install driver software from the CD:
1. Ensure the printer and scanner are NOT connected to the target PC.
2. Select Install Printer/Scanner Drivers from the installation menu screen.
3. You are prompted to select your printer model. The product number can be found on the
underside of the printer. You are also prompted to select the printer connection method. For
USB devices select USB. For ECP devices select either LPT1 or LPT2 depending on the