User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 40 of 43
Appendix H. Manual Driver Installation
If installing the ECP printer and scanner:
1. Navigate to:
<installation directory>\Device Drivers\WinNT4_2K_XP\Ecp\ V100133_061212
2. Copy cy.sys into:
C:\windows\system32\drivers\
If installing the USB printer and scanner:
1. Navigate to:
<installation directory>\Device Drivers\WinNT4_2K_XP\usb
2. Copy ezusb.sys into:
C:\windows\system32\drivers\
3. The following Windows DLLs need to exist in \windows\system32\
mfc42u.dll
msvcrtd.dll
mfc42d.dll
If these files are missing, locate the latest versions of them either from your Windows
installation CD or the Internet, and copy them to the drivers folder.
4. Edit Cy.ini and set IoBase, Irq, and Dma to same values as in there are is BIOS for the ECP
port.
5. When you have connected your USB printer and scanner, and Windows detected the new
hardware, provide Windows with the path to the ezusbw2k.inf file located in:
<installation directory>\Device Drivers\WinNT4_2K_XP
For ECP printer and scanner installs only
1. Navigate to:
<installation directory>\Device Drivers\WinNT4_2K_XP
2. Drag either cyw2k-Lpt1.ini or cyw2k-Lpt2.ini (depending upon the LTP port you are using)
onto regini.exe.
3. Run Servicer.exe
4. Click Start.
5. Press OK after the Cy service has
started and is running. (See Image 6).
This enables the driver for this session.
Image 6