User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 38 of 43
Appendix F. Thermal Paper Specification
Product Series
Max Roll
Diameter
Logo/End
of Roll
Thermal
Coating
CST2000 Lottery
Terminal
150 mm
Outside
Inside
CST2301 Plastic
Gaming Machine
200 mm
Inside
Outside
CST2400 Kiosk
200 mm
Inside
Outside
CST2304 Metal
Gaming Machine
200 mm
Inside
Outside
CST7000 Thermal
printer & barcode
reader
200 mm
Inside /
Outside
Outside
CST7001 Thermal
printer & barcode
reader
150 mm
Inside
Outside
CST2308 Nikita
200 mm
Inside
Outside
Thermal Paper specification:
Only use recommended paper. Other equivalent grade paper may
require approval; otherwise it may invalidate the printer warranty.
The use of materials which does not meet this specification will
affect the warranty of the printer.
Specification details:
Paper that offers resistance to plasticizers, oil and
water. Good scratch resistance.
Semi-protected.
Heat and pressure sensitive paper
Basic Weight: 70 to 80 g/m2.
Thickness: 65 to 85 microns.
Opacity: 85% minimum.
Brightness: minimum 65%.
Surface smoothness: 500 seconds min- coated.
Plastic centre core of 25 mm inside diameter.
Paper and ink must be free of Calcium (Ca) and
Silicon (S).
Recommended paper: Ricoh 130LSB.
End of roll indicator
Two types:
CST7000 Thermal Printer:
CST7000 requires the 20mm black strip applied to the coated side
on a paper roll at 10mm from the left edge as shown:
All other Printers:
Continuous stripe on non thermal-coated side. Refer to table 1
above.
20mm wide strip, equidistant from both edges in black matt light
absorbent ink.
Strip length one meter only.
Artwork:
Uncoated side
The CST7000 thermal printer has no colour artwork printing
restrictions if the artwork is printed on the inside.
For all other products
The paper sensors on the printer reflect the red colour. The artwork
is permitted in Pantone Warm Red C colour.
Dark colour artwork and logo e.g. Black, dark Blue, dark Brown etc.
may be permitted provided it meets one of these conditions:
1: Dark colour logo up to maximum 25 percent tint may be allowed
after it has been approved by Cyberview Technology Ltd.
2: The design of artwork with dark colours is permitted if it is kept
clear of the void areas shown below:
Coated side:
Printing artwork on the coated side is permitted with maximum 5%
tint in Pantone Warm Red.
Approval:
All artwork and logo designs to be printed on to the paper rolls
must be approved by Cyberview Technology Ltd. For further
assistance, contact Cyberview Technology Ltd
12 mm
8 mm
8 mm
Strips for dark
Artwork on a
, 12mm &
16 mm
36 mm
Vo
id
a
r
e
a
V
o
i
d
a
r
e
a
80 mm
Black Strip
20 mm
10 mm
50 mm
CST7000 thermal printer paper
outside coated
Ø 150 mm / 200mm
Print Side
Core: Inside Ø 25 mm
Note: Plastic “not fixed
to paper”
Paper Width: 80 mm
+0/-1 mm
Ricoh 130 LSB
Paper length = At 150mm, approx. 210m.
= At 200mm, approx. 370m.
Thermal coated side, see table below
Inside thermal coated
Outside thermal coated