User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 26 of 43
11. Scanner Maintenance
11.1 Routine cleaning
Perform the following cleaning procedure: every week, whenever black lines appear on the scanned
image, or when scanning errors occur.
1
2
Remove the scanner cover by holding at
both ends and pulling upwards.
Locate the two green lock levers that secure
the feed roller. Place both thumbs on these
lock levers, and push backwards until both
levers are oriented upwards.
3
4
The feed roller is released when the 2 lock
levers are in the upward position.
Remove the feed roller by holding both lock
levers and lifting straight up to expose the
sensor glass.
5
Gently wipe the glass from side to side
using a new cleaning wipe ensuring the
glass surface is completely free from
deposits.
Replace the feed roller ensuring the lock
levers are seated securely. Once engaged
in their slots, turn the green level locks
toward the front of the scanner. Replace the
scanner cover.
Lock-lever oriented upward