User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 19 of 43
5. To restart the initialization sequence, click
6. The scanner cannot operate until the Init OK: message is displayed.
7.3 Calibrating the scanner
The following calibration procedure is to be performed using photo-quality white paper specially cut
with a 223 mm width. Using other white paper for scanner calibration may result in scanning errors.
Ensure the white side of the photo paper faces towards the front of the scanner.
1. Start EngBench.exe (if it is not already running).
2. Select CAL from the EngBench menu bar.
3. The Insert White Paper dialog box is displayed:
4. Insert the 223mm edge of the calibration paper into the scanner input slot as shown below,
ensuring that the paper is properly centred.
“Init KO” indicates scanner is not
functioning