User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 18 of 43
7. Scanner Functional Verification
Verification of scanner function is performed using the Cyberview EngBench utility supplied with the
SDK installation.
7.1 Installing EngBench
EngBench is a PC hardware independent executable. Using EngBench you can test all printer and
scanner operations as well as some specific terminal functions.
The EngBench application is installed as part of the SDK into the default location: <install
location>\Printer Scanner SDK\EngBench\
An EngBench user interface quick reference is available on page 39.
7.2 Testing the scanner
1. Run EngBench.exe from its installation location.
2. The EngBench user interface is displayed as follows:
3. Press F6 to display the Messages window. Examine the Status Display or the Messages
window to ensure there are no errors. The message Config not FOUND, PLEASE CALIBRATE
means that EngBench has detected that the scanner has not been calibrated. This will be done
shortly.
4. An Init KO message indicates an error with connection. In this case, verify all connections and
ensure that the power supply is ON.
This messages window is displayed
by pressing F6
Press F6 again to turn it OFF
Status Display