User manual

Cyberview scanner and thermal printer - Installation and User Manual 15 October 2007
Commercial-in-Confidence Page 12 of 43
IF the above values are not configured, set them as in the following:
a) Click Change Setting...
b) Use the drop-down arrow to select a Basic Configuration 000x.
Image 4
Image 5
c) If DMA shows a „?‟ then double-click it to display the dialog shown in image 5. Set the value to
3 and ensure that Conflict Information field displays: No devices are conflicting.
IF port configuration problems occur, check:
a) BIOS: If appropriate, make setting changes to the BIOS.
b) If settings must be made, ensure that ECP, Interrupt and DMA are selected.
c) Ensure that the parallel port is a motherboard-based port, and not an add-on PCI card.
9. Reboot the PC.