Setup Guideline for new KVM 1080 IP • IP 1080 Remote Access • Quad-core Processor • HTML-base & Java-free • Enterprise IP Authentication • BIOS-level Access Designed and manufactured by Austin Hughes UM-CV-IP-S101_H101-Q222V1 www.austin-hughes.
Please make sure to follow the below steps to setup your KVM IP properly. I. Configure the target server The target server is the server that connected to the IP KVM Switch. Before use IP remote access, you need to turn off mouse acceleration of all target servers. Please refer to below for Windows operating system. Mouse setting From the Control Panel, double-click the Mouse icon to open the Mouse Properties dialog box. 1. Move the pointer speed slider to the default of 50%.
II. Logging in to IP KVM The default IP address is as below: IP address: 192.168.1.22 Subnet mask: 255.255.255.0 Gateway: 192.168.1.1 IP KVM model with single IP port: IP KVM model with dual IP ports: - - The 1st IP address 192.168.1.22 - The 2nd IP address 192.168.1.23 Default address 192.168.1.22 To log in to the IP KVM do as follows: 1. Open the browser on the client, in the address bar, enter the default IP KVM address ( 192.168.1.22 ) 2.
IV. Launch remote console Click Control and then Remote console, the Remote console Preview is displayed, then Click Connect, the remote console opens in a separate windows. When first start, the local mouse is not synchronized with the remote mouse, it appears at a distance to each other, press the Mouse Sync once ( positioning top left corner ), the mouse will align.