User's Manual

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM

integrator is still responsible for testing their end-product for any additional compliance requirements required

with this module installed

IMPORTANT NOTE:

This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the

rules that apply to the product into which this certified RF module is integrated.

Additional testing and certification may be necessary when multiple modules are used.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the

antenna while this end product is installed and operated. The end user has to be informed that the FCC

radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also

be informed that any changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then additional FCC

part 15.19 statement is required to be available in the users manual: This device complies with Part 15 of FCC

rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference

and (2) this device must accept any interference received, including interference that may cause undesired

operation.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains TX FCC ID: N89-WU182

". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be

available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

End Product Labeling

This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm

may be maintained between the antenna and users. The final end product must be labeled in a visible area with