User's Manual

2
3. Introduction
The WU182-LO is a module based on a highly integrated Wi-Fi single chip which supports 300 Mbps PHY rate. It
fully complies with IEEE 802.11n and IEEE 802.11 b/g standards, offering feature-rich wireless connectivity at high
standards, and delivering reliable, cost-effective throughput from an extended distance.
Optimized RF architecture and baseband algorithms provide superb performance and low power consumption.
Intelligent MAC design deploys a high efficient DMA engine and hardware data processing accelerators which
offloads the host processor.
The WU182-LO is designed to support standard based features in the areas of security, quality of service and
international regulations, giving end users the greatest performance any time and in any circumstance.
Features and Benefits
IEEE 802.11 b/g/n compliant
Embedded high-performance 32-bit RISC microprocessor
Highly integrated RF with 55nm CMOS technology
2T2R mode with support of 300Mbps PHY rate
Integrate high efficiency switching regulator
Best-in-class power consumption performance
6-pin header interface for USB signal and power
1/2/3/4-wire PTA Wi-Fi / Bluetooth coexistence support
802.11 d/h/k support
Security support for WFA WPA/WPA2 personal, WPS2.0, WAPI
Supports 802.11w protected managed frames
QoS support of WFA WMM, WMM PS
Supports Wi-Fi Direct
Fully compliance with USB v2.0 High-speed mode
Per packet transmit power control
Antenna Detection