User's Manual

Broadband Wireless Router User Guide
- 27 -
27
4-6 Device Administration Settings
This feature allows the administrator to manage the Broadband Wireless Router by
setting certain parameters. For security reasons, it is strongly recommended that you
set Passwords and so that only authorized persons are able to magage this Broadband
Wireless Router. If the Password is left blank, all users on your network can access this
router simply by entering the unit’s IP Address into their web browser’s location
window.
 Firmware Version This field shows the installed version of the firmware.
 Administrator Password Enter the password you want to use into the
“Password Change” field and re-enter it into the “Password Confirm”
field for confirmation. Be sure that the password is less than 64 characters
long and without any special characters or spaces.
 WAN MAC Change The WAN MAC address can be changed from the
original values if necessary. Some ISPs require users to change the WAN
MAC address to a registered one when users change their access equipment.
 Remote Management Check “Enable” to allow you to configure the
Broadband Wireless Router from the WAN side. To access the setting page
from the external side, enter “http://<WAN IP Address>:8080” into the
web browser address bar and press the “Enter” key.
 MTU Check Enable if you want to set a maximum limitation for incoming
and outgoing packet size. Enter the maximum packet size you wish to set in
the “Size” column.
 Reset Device Select “Yes” if you want to clear a connection, reboot, and