User's Manual

Broadband Wireless Router User Guide
- 18 -
18
(end-user side) and DSLAM (ISP side). If your ISP uses PPTP to establish the
connection, you should select this item and follow the steps below.
 Specify WAN IP Address Enter the IP address provided by your ISP. If your
ISP provides you an Alcatel Speed Touch
TM
modem, it is suggested that you
enter 10.0.0.150 in this column.
 Subnet Mask Enter the subnet mask values provided by your ISP.
 Default Gateway IP Address Your ISP will provide you with the Default
Gateway IP Address. If your ISP provides you an Alcatel Speed Touch
TM
modem, it is suggested that you enter the 10.0.0.138 in this column.
 User Name Enter the user name provided by your ISP.
 Password Enter the password provided by your ISP.
 Connect-on-demand is a utility used to trigger the PPTP session when there
is packet being sent through the WAN port while it is on disconnected
situation. Check the radio button to make this function active, and then you
must enter the number of minutes you wish the network to remain idle
before disconnection occurs in the “Max Idle Time” location. Note that this
function is for PPTP only.
 Keep Alive This function keeps your PPTP connection enable even if it
remains idle. However, in some situation, PPTP session cannot be
established immediately after disconnection. This is because the system on
the ISP’s site may need a little time to restore itself. You may need to check
with your ISP to obtain detail of how long you need to wait before
re-establish the PPTP session. Enter this information in the “Redial Period”
field.
When you have properly configured the Setup page, click “Apply”. You can now test
to see if the settings are all correct by attempting to connect to the Internet.